Page 1 of 1
Panel designing
Posted: Mon May 01, 2006 3:42 pm
by Dtaylor
I am missing both side panels for my Elite SB. I need suggestions on replacement. I cannot afford new paels, here's the parts I have access to:
-metal piping
-sheet metal
-metal rods
-welder
Posted: Mon May 01, 2006 6:07 pm
by fizzle
sheet metal and a few hamers and dollies and bags full of sand, and you should be able to pull of something that will cover your needs, then off course you'll need to cut off the excess.
let us all see how it turns out.
sheet aluminum - wicked cheap and wicked easy to hammer out.
just a tip - oh and its light.
okay stay safe - wear gloves.
Posted: Tue May 02, 2006 10:01 am
by mopedman
um that would be hard but would be sweet if you got it to work, did you see if there are any on ebay
body panels
Posted: Wed May 03, 2006 12:06 am
by prattj1
If I were in your position I would make a body out of foam. Anything from Godzilla to a trojan horse.
Posted: Wed May 03, 2006 10:47 pm
by deathwish
lol
Posted: Thu May 04, 2006 8:06 am
by MySpree
if i was in that situation, id just wait for ebay.
Posted: Thu May 04, 2006 11:41 pm
by myhonda
i was in that situation. pics in the moped pics topic