Page 2 of 2

Posted: Tue Apr 15, 2008 9:28 pm
by Dac
http://www.hondaspree.net/phpBB2/viewto ... sc&start=0
One last link for you.
this one shows his homemade mount.

Posted: Tue Apr 15, 2008 10:10 pm
by scooter trash
wow. he did nice work wish he was still around.

Now. Am i correct? dio swap= fabing up new mounts and loss of center stand.
any elite engine=less fab still have to get rid of the center stand but engine almost bolts right up

Posted: Wed Apr 30, 2008 4:55 am
by tru72
all you need is a S mount and cut to fit.. you wil need a side stand for sure. If you really trying to get it to look stock, you wil need to also shorten the mount. Also need to relocated the shock mount. Also cut the plastics to fit, depending on what pipe and carb set up..
good luck!
aloha
D