screw adjustment

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
nextalcupfan
Noob
Noob
Posts: 7
Joined: Sat May 06, 2006 6:17 pm
Location: missouri

screw adjustment

Post by nextalcupfan »

i read the adjustment recemendations for my scooter and it said for 1 1/2 turns. ok i do that and it still doesnt have the same power. so i richen it up. then it has even less power. so i reset it and this time lean it out. then it has more power but still dosent run right.
Owner of a 1986 Spree NQ50
nextalcupfan
Noob
Noob
Posts: 7
Joined: Sat May 06, 2006 6:17 pm
Location: missouri

Post by nextalcupfan »

also at one time it wouldnt run at all. i decided it was dirt in the carb so i took it to get the carb rebulit. when i got it back it ran but it was never the same. before i could get on it start (started easily) it and go no warming up had plenty of power to plus no smoke from the exaust. but now i have to warm it up, it sometimes pours out white smoke and has much less power, and is hard starting.
Owner of a 1986 Spree NQ50
User avatar
scoot2er
BMX
BMX
Posts: 33
Joined: Sat May 13, 2006 11:21 am
Location: Sacramento California

carb clean

Post by scoot2er »

did u take the carb apart and thread the tiny holes with a guitar string? that's what i did. then I got some carb cleaner and sprayed the heck out of it. My scooter was having similar problems before that. and that carb adjustment of 1 1\2 turns is correct if stock. maybe you have performance mods?
What it is?
nextalcupfan
Noob
Noob
Posts: 7
Joined: Sat May 06, 2006 6:17 pm
Location: missouri

Post by nextalcupfan »

no performence mods the person i got it from was a little old lay who didnt even know it didnt have an air cleaner. also is it suposed to have a vacum tube? it has a spot for something else. its on top of the carb tword the engine sticking straight up
Owner of a 1986 Spree NQ50
User avatar
scoot2er
BMX
BMX
Posts: 33
Joined: Sat May 13, 2006 11:21 am
Location: Sacramento California

Post by scoot2er »

Okay check this site out. The info here helped me alot. www.scootertherapy.com . Cruise thru the site for maintenance info. They have a good pic of a spree carb all dissassembled there. use it to take yours apart and find out whats missing or wrong. very helpful. Sounds like you have an adjustment problem where the throttle cable attaches to the carb on top. Just fiddle with it for an hour or two in very small increments. don't be afraid of hurting your fingers.
What it is?
nextalcupfan
Noob
Noob
Posts: 7
Joined: Sat May 06, 2006 6:17 pm
Location: missouri

Post by nextalcupfan »

thank you ill try it
Owner of a 1986 Spree NQ50
User avatar
MySpree
CBR1000RR
CBR1000RR
Posts: 3291
Joined: Mon Jul 23, 1973 10:24 am
Location: Troy michigan
Contact:

Post by MySpree »

scootertherepy has helped me be4 too
Image
Post Reply