No spark.

sjleto · Post by **sjleto** » Thu Apr 14, 2011 5:50 pm

About a month ago I put in a big bore kit. First time it fired right up and idled fine. Turned it off and since then I haven't been able to start it. Originally my starter motor didn't seem to have enough power to turn it over but I believe that was caused by my kick starter gears being in the way. I recently replaced all the kick starter parts and now that seems to work along with my electric starter. Now I have no spark. Tried a new spark plug and that didn't work. Bought a $50 parts spree and swapped over all of its electrical parts and still no spark. Any thoughts?

Thanks.

spewya · Post by **spewya** » Fri Apr 15, 2011 11:54 pm

check the main fuse,coil,cdi unit,
maby your harnes is not getting a good ground

evilone · Post by **evilone** » Sat Apr 16, 2011 9:43 am

Hold the left brake lever?

Bear45-70 · Post by **Bear45-70** » Sat Apr 16, 2011 12:44 pm

Make sure the "Stop/Run" switch is in the Run position.

sjleto · Post by **sjleto** » Sun Apr 17, 2011 2:24 pm

Turns out that when we were checking the starter, a ground wire came loose. Looks like the previous owner rigged it up with electrical tape. Reground the wire and now will begin breaking in the BBK.

Thanks for the suggestions.

martynkim · Post by **martynkim** » Mon Apr 18, 2011 10:26 pm

sjleto wrote:Turns out that when we were checking the starter, a ground wire came loose. Looks like the previous owner rigged it up with electrical tape. Reground the wire and now will begin breaking in the BBK.

Thanks for the suggestions.

I was gonna say GAS in the tank? Then I saw this post....

spewya · Post by **spewya** » Tue Apr 19, 2011 9:11 pm

haha what i say

Honda Spree and Elite 50 Forums

No spark.

No spark.

Re: No spark.

Re: No spark.

Re: No spark.

Re: No spark.

Re: No spark.

Re: No spark.