Honda Spree and Elite 50 Forums

motormike wrote: Wed Jun 23, 2021 2:37 am ...oh boy.

yeah my thoughts exactly, think it's worth taking the cylinder in to get machined or should I look around for a replacement?

Good question, I was getting low compression and the performance was super sluggish at low speeds, I honestly wasn't able to get it up to full speed at all. Eventually I couldn't get it to turn over. I figured the rings were worn out and needed replacing. I finally was able to work the cylinder and ...

What's up ya'll,
Currently working on replacing the piston with one I ordered from chopchop on ebay, however when I go to pull out the cylinder it gets stuck on what I assume are the rings. The cylinder is able to be lifted about 1/4" to 1/2" off the mating surface before it gets too tough to pull ...

Hey thanks for the help Meatball, I went ahead and did everything you recommended. I did not see anything wrong with the gears in the transmission case nor did I see much wrong with the bearing the final gear passes through. However, the transmission cover bearing will probably have to be replaced ...

Hello, I've been lurking for awhile and with the knowledge I have gained here and from the manual, I finally got a 1986 Honda Spree I had running again after five years of sitting in my parents garage while I was away at college. It took awhile, but I got it to start thea few days ago and ripped ...